Appliance S-Type Lanner

Welcome to the SCION world! Here you can find initial connection instructions for your Anapaya S-type device. Once the device is unpacked and installed in your technical environment, proceed with the following steps on the Rear Panel:

  1. Connect the RJ45 cable to the termination point of your WAN access on port 3.

  2. Connect the RJ45 cable to your LAN on port 5.

  3. Plug the power supply DC.

  4. Turn the device on by pressing the power button P.

Note

Your support may indicate other ports to connect the RJ45 cables to.

../../../../../_images/s-type-front.drawio3.svg

After a few minutes, the LEDs on the front panel should have the following statuses:

  1. System should be solid green.

  2. Power should be solid green.

  3. The LED 3/4 represents the WAN port(s). The link status of the port 3 should be blinking amber.

  4. The LED 5/6/7/8 represents the LAN port(s). The link status of the port 5 should be blinking amber.

../../../../../_images/s-type-back.drawio3.svg

Note

If the IP addresses has not been assigned automatically via DHCP:

  1. Connect a serial cable to the console port (5 on the first picture).

  2. Then connect to the serial console using a baud rate of 115200. Authenticate to the appliance using the default credentials, login: anapaya and password: anapaya.

  3. Once logged in, you can setup the WAN IP parameters as indicated by your support. For more information consult docs.anapaya.net.

The possible statuses of the RJ45 network LEDs (3 to 8) are

Upper LED (speed)

Solid green

Operating as a FastEthernet connection (100 Mbps)

Solid amber

Operating as a GigaEthernet connection (1’000 Mbps)

Off

No link has been established

Lower LED (link status)

Solid amber

Link has been established and there is no activity on this port

Blinking amber

Link has been established and there is activity on this port

Off

No link has been established

Interface mapping

Interface Name

Port Nr. on Device

Port Usage

Port Type

enp2s0f0

1

Unassigned

Fiber – SFP 1G

enp2s0f1

2

Unassigned

Fiber – SFP 1G

enp2s0f2

3

Default WAN interface

RJ45 – 1000BaseT

enp2s0f3

4

Unassigned

RJ45 – 1000BaseT

enp10s0f0

7

Unassigned

RJ45 – 1000BaseT

enp10s0f1

8

Unassigned

RJ45 – 1000BaseT

enp8s0f0

5

Default LAN interface

RJ45 – 1000BaseT

enp8s0f1

6

Unassigned

RJ45 – 1000BaseT

The official manual of the S-type hardware (Lanner L-1515 4C) can be found at:

https://www.whiteboxsolution.com/product/l-1515/